Taizhou JinQuan Copper Co., Ltd.
Taizhou JinQuan Copper Co., Ltd. Guided by Market and Existing by Quality
Add to Cart
Copper 11/4''X11/4'' 90 Degree Hose Elbow
Introduction
Connects Copper,PEX and CPVC... pipe in any combination.
Pex Stiffener for PEX pipe only..
Approved for use underground and behind walls without access panels.
Certified for use in hydronic heating and potable water.
Push-Fit products are very convenient to install, just need to push the pipe completely into the fitting, needn't use any tools, such as spanner.
Characteristic:
1) Made in brass material or carbon steel with nickel plated, and sealed with NBR
2) Easy to connect tube by one touch, and the is applicable for Polyurethane tubing and Nylon tubing
Specification:
| Specification | Parameter | ||||
| Name | Copper 11/4''X11/4'' 90 Degree Hose Elbow | ||||
| Applicable medium | Compressed Air, Vacuum | ||||
| Pressure range | 0~1.0 MPa | ||||
| Proof pressure | 1.5 MPa | ||||
| Negative range | -100kpa (10Torr) | ||||
| Temperature range | 5°C~60°C | ||||
| Applicable tube | PU hose, Nylon hose, PE hose | ||||
Pictures
Installation
Select the correct size fitting and pipe for the job. Check that fittings and pipe are clean, in good condition and are free from damage and foreign objects.Cut the pipe so that the ends are square.Ensure that there are no burrs or damage to the cut end.Once the pipe end is cut square and clean,use a permanent marker to mark the insert depth on the outside of the pipe.This mark is used to ensure that the joint is assembled correctly.To assemble correctly,the pipe needs to be pushed into the fitting untill it meets the tube stop.Follow these three steps to insert the pipe into the fitting.
1.lnsert the pipe through the release collar against the grab ring.
2.Push the pipe firmly with a slight twisting action until it reaches
the tube stop.
3.To ensure that the pipe is correctly inserted, check that the depth
mark is within 0.005 in (0.13 mm) of the end of the release collar.
Disconnection of the joint can only occur by using the PUSHLOCK removal tool.By applying pressure to the release collar with the re-
moval tool, the grab ring teeth are splayed.This action releases the pipe, allowing it to be removed from the fitting.
1.Place the PUSHLOCK removal tool around the pipe with the non-
branded face against the release collar.The end with the size dis-
played on the removal tool should be positioned around the pipe and
the other end around the neck of the fitting.
2.Push the removal tool against the release collar and pull the pipe
with a twisting action to release the pipe.
3.Check the fitting and pipe end for damage.The fitting and pipe
should be free of damage, foreign objects and marks on the outside
diameter. If the pipe is damaged or marked, then cut and use a new
section of pipe.
FAQ
Q: Are you trading company or manufacturer ?
A: We are Factory and trading combination, some items produce and other items are outsourcing.
Q: What’s your lead time?
A: Generally it is 5-7 days if the goods are in stock. or it is 15-20 days if the goods are not in stock, it is according to quantity.
Q: Do you provide samples ? Free or in charge ?
A: Yes, we could offer free samples but not including shipping cost.
Q: What’s your pay term?
A: Payment<=1000USD, 100% in advance. Payment>=1000USD, 30% T/T in advance ,balance before shipment.
Q:Can I place a credit insurance order online?
A:Yes,sure.